Watchguard AP322 Hardware Manual page 11

Hide thumbs Also See for AP322:

Table of Contents

Ethernet Power Injector (Optional)

You can power the WatchGuard AP with an optional Ethernet Power Injector. This PoE+ capable device allows

you to power the WatchGuard AP through an existing Ethernet connection. With this feature, you do not have

to position your WatchGuard AP near a power outlet.

This device complies with IEEE 802.3at/af PoE specifications. Do not use any PoE adapters that are not

IEEE 802.3at/af compliant as they may damage your device.

Connect the Ethernet Power Injector

To connect an Ethernet Power Injector to the WatchGuard AP:

1. Plug the Ethernet Power Injector into an AC power source.

2. Connect an Ethernet cable from your network backbone (for example, PoE+ capable router, switch, or

hub) to the LAN connector on the Ethernet Power Injector.

3. Connect an Ethernet cable from the LAN1 PoE+ interface on the AP to the PoE connector on the

Ethernet Power Injector.

Hardware Guide

Hardware Specifications

Table of Contents