HP 8920B Programmer's Manual page 613

Requirements for Using The ANALOG MEAS Screen
CAUTION:
How To Program The ANALOG MEAS Screen
AF Anl In
AF Freq
The Test Set must be in the connected state (that is, the
lit) in order to use the ANALOG MEAS screen.
The mobile station's speaker output must be connected to the Test Set's AUDIO
IN connector and the mobile station's microphone input must be connected to the
Test Set's AUDIO OUT connector in order to use the ANALOG MEAS screen.
Refer to
"Connecting a Mobile Station to the Test Set" on page 465
information. If the mobile station does not have audio connections the ANALOG
MEAS screen cannot be used.
The host firmware does not monitor the mobile station's transmitted carrier power while
the ANALOG MEAS screen is displayed. If the power falls below 0.0005 Watts no error
message is displayed nor will the Test Set terminate the call while on the ANALOG MEAS
screen.
The ANALOG MEAS screen combines some of the Test Set's
fields and some of the Test Set's
purpose of testing the audio characteristics of the mobile station.
Only those fields which are pertinent to testing the mobile station's audio
characteristics have been combined onto the
Since the fields on the
those fields are programmed exactly as they would be on their home screen. To
set up the fields, program the appropriate instrument. To make measurements use
the MEASure subsystem.
This field selects the input for the Audio Frequency analyzer.
in chapter , on page 91
This field is a one-of-many field used to select the type of measurement to be
made by the Audio Frequency Analyzer on the audio signal being measured.
"Measure," in chapter , on page 163
Chapter 8, Programming The Call Processing Subsystem
RF Generator
screen are imported from other screens
ANALOG MEAS
for programming command syntax.
for programming command syntax.
Programming The ANALOG MEAS Screen
annunciator is
Connect
for connection
Audio Analyzer
fields onto one screen for the
screen.
ANALOG MEAS
See "AF Analyzer,"
See
613