HP 8920B Programmer's Manual page 505

SAT:
The field is divided into two fields:
SAT:
• The left-hand field displays the current SAT tone frequency assignment for the current
voice channel being used by the Test Set and the mobile station.
The Sat field only displays a value when the system type is set to AMPS, TACS,
JTACS or when NAMPS Ch Loc: is set to Wide. The Test Set must also be actively
connected on a voice channel (that is, the Connect annunciator is lit). A "-" is dis-
played if a mobile station is not actively connected on a voice channel or the system
type is NAMPS and Ch Loc: is set to Lower, Middle, or Upper.
This is a read only field.
The :AVCSat? query command is used to query the contents of the left-hand subfield.
There is no command form of the :AVCSat? command.
Syntax
:AVCSat?
Example
OUTPUT 714;"CALLP:AMPS:AVCS?"
ENTER 714;Active_vc_sat$
• The right-hand field (highlighted field) is used to set the SAT Color Code (SCC) to be
used on the designated voice channel (the channel number entered into the Chan:
right-hand subfield).
The :SATone command is used to control the right-hand subfield.
The query form of the command (that is, :SATone?) can be used to determine the cur-
rent SAT Color Code (SCC) setting.
Syntax
:SATone <'><5970HZ/6000HZ/6030HZ><'>
:SATone?
Example
OUTPUT 714;"CALLP:AMPS:SAT?"
OUTPUT 714;"CALLP:AMPS:SAT '5970HZ'"
ENTER 714;Sat_color_code$
Chapter 8, Programming The Call Processing Subsystem
Programming The CALL CONTROL Screen
505