HP 8920B Programmer's Manual page 212

Equivalent Front-Panel Key Commands
NOTE:
NOTE:
212
To Set the Meter High End and Low End Point Display Units.
:METer:HEND:DUNits and :MEter:LEND:DUNits commands to set the analog
bar-graph meter high end point and low end point Display Units. Refer to
"Display Units (DUNits)" on page 67
Syntax
:METer:HEND:DUNits <disp_units>
:METer:HEND:DUNits <disp_units>
Example
OUTPUT 714;"MEAS:RFR:POW:MET:HEND:DUN DBM"
OUTPUT 714;"MEAS:RFR:POW:MET:LEND:DUN DBM"
This sets the high end point and low end point display units of the analog
bar-graph meter for the TX Power measurement to DBM.
When querying the METER Data Function through HP-IB, the Test Set always
returns numeric values in Attribute Units, regardless of the current Display Units
or HP-IB Units settings. Numeric values are expressed in scientific notation.
To Query the Meter High End and Low End Point Display Units.
:METer:HEND:DUNits? and :MEter:LEND:DUNits? commands to query the
analog bar-graph meter high end point and low end point Display Units. Refer to
"Display Units (DUNits)" on page 67
Syntax
:METer:HEND:DUNits?
:METer:LEND:DUNits?
Example
OUTPUT 714;"MEAS:RFR:POW:MET:HEND:DUN?
OUTPUT 714;"MEAS:RFR:POW:MET:LEND:DUN?"
ENTER 714;Met_hidisp_unit$
ENTER 714;Met_lodisp_unit$
This queries the high end point and low end point display units of the
analog bar-graph meter for the TX Power measurement.
When querying the METER Data Function through HP-IB, the Test Set always
returns numeric values in Attribute Units, regardless of the current Display Units
or HP-IB Units settings. Numeric values are expressed in scientific notation.
for description of Display Units.
for description of Display Units.
Use the
Use the