Troubleshooting - Kaco blueplanet 3.0 TL3 M2 WM OD IIG0 Manual

11 | Maintenance and troubleshooting
Fault LED (red)
OS (operating status)
11.7

Troubleshooting

The following table lists the possible status and fault messages, the ProLog© status messages that the device
can display by means of the LC display / web interface and the LEDs.
No. Grid LED
LED
1 Waiting for feed-in
2 Insufficient generator
voltage / insufficient battery
voltage
3 Constant volt. control
4 Yield counter for daily and
annual yields are displayed
Page 76
Status
– The fault relay releases again.
– The device feeds back into the grid again after a country-
specific time period.
Display
The start voltage (pre-)set in the device is
higher than the actual voltage. The device
waits for the solar voltage to exceed an ad-
justable value and for a stable grid.
Insufficient generator voltage and power,
status before the transition to night shutdown.
No MPP control occurs. When feed-in begins,
a constant generator voltage is fed in (85% of
the measured open circuit voltage) for a short
period
In cases of sufficient sunlight, the unit feeds
into the grid with MPP control so as to maxim-
ise yields.
KACO blueplanet 3.0 TL3 KACO blueplanet 4.0 TL3 KACO blueplanet 5.0 TL3 KACO blueplanet 6.5 TL3 KACO
blueplanet 7.5 TL3 KACO blueplanet 8.6 TL3 KACO blueplanet 9.0 TL3 KACO blueplanet 10.0 TL3
Manual
Explanation
Status description
LED
Off
Action Pers
.
Check whether the B
start voltage was
set too high in the
menu.
Insufficient DC B
voltage or voltage
fails under load (in-
sufficient DC power)
a) Compare the
voltage measured
with the no-load
voltage expected. b)
Check if the DC isol-
ator switch is
switched off c)
Check whether a D
a) Does this status -
appear in the morn-
ing and evening
when sunlight con-
ditions are poor? b)
Does this status ap-
pear when sunlight
conditions are
good? Please check
the constant voltage
control settings in
the menu. Internal
note: The device
password is re-
quired to alter these
settings
- B