Maintenance/Troubleshooting; Visual Inspection; Cleaning The Housing; Cleaning The Heat Sink - Kaco blueplanet 29.0 TL3 Operating Instructions Manual

Maintenance/Troubleshooting

2. If you would like to perform the update, select the "Yes" button. In the case of "No", pressing the "Enter" key
stops the update process and the unit goes into feed-in mode.
» The inverter begins the update.
- The update has been imported in full once the message "Software update successful" appears.
- If the update has failed, the message "Software update incomplete" appears.
3. When a fault occurs, the update process must be repeated.
Alternatively, you can check to see if the update was successful in the menu:
Displaying the software version
Open the Information / SW version menu.
» The inverter will display the versions and checksums of the software that is currently loaded.
9 Maintenance/Troubleshooting
9.1

Visual inspection

Inspect the inverter and the cables for exterior visible damage and note the operating status display of the inverter.
In case of damage, notify your installer. Repairs may only be carried out by authorised electricians.
NOTE
There are components in the housing of the inverter which may only be repaired by our KACO
customer service team.
The inverter should be checked for proper operation by a qualified electrician at regular intervals
and if you experience problems, you should always contact our customer service team..
9.2

Cleaning the housing

DANGER
Lethal voltages in the inverter!
Serious injuries or death can result if moisture enters the system.
›
Only use completely dry objects to clean the inverter.
›
The inverter should only be cleaned from the outside.
Cleaning the inverter
Do not use compressed air!
Use a vacuum cleaner or a soft brush to remove dust from the fan cover and from the top of the inverter on a
regular basis.
Remove dust from the ventilation inlets if necessary.
9.3

Cleaning the heat sink

CAUTION
Risk of burns from hot surface.
Heat sinks become very hot when in operation!
›
Never touch the heat sinks after operation.
›
Allow the heat sinks at least 10 minutes to cool down before cleaning.
Operating Instructions KACO blueplanet 29.0TL3
EN
Page 49