Overview Of System Board Components - Viglen VIG610M Manual

Table 2: Motherboard Connection
A: Rear System Fan
B: TPM Module connector
C: ATX 12V Power Connector
D: LGA 775 CPU Socket
E: S/PDIF-Out Connector
F: CPU Fan Connector
G: Memory DIMM Slots
H: ATX 24-Pin Power Connector
I: IDE Connector
J: Front System Fan Header
K: Front Panel Connector 1 (Speaker,
Power LED)
L: Serial ATA Connectors

Overview of System Board Components

A – System Fan1
This is used to keep the Motherboard components and other components cool.
B – TPM Module Connector
This connector connects to a TPM (Trusted Platform Module) module.
C – ATX 12V Power Connector
This 12V power connector is used to provide power to the CPU
D – LGA775 pin CPU socket
CPU sits in the LGA775 pin socket.
E – S/PDIF-Out Connector
This connector is used to connect S/PDIF (Sony & Phillips digital Interconnect
Format) interface for digital transmission.
F – CPU Fan Header
Fan header dedicated purely for the Heatsink to cool the CPU.
G – 2 x DIMM Slots
Insert Memory modules 400/533/667 MHz.
H – ATX 24 pin Power Connector
This is the main power connector for the motherboard.
I – IDE Connector
This can be used to connect an IDE Hard Disk Drive or even a CD-ROM drive.
J – Front System Fan header
This is used to keep the Motherboard components and other components cool.
K – Front Panel Connector 1
Controls the Hard Disk Drive LED, Power Switch, Reset Switch and Power LED
V1.0
M: Front Panel Connector 2 (Reset
Switch, HDDLED, Power LED, Power
Switch)
N: USB headers
O: Clear CMOS Jumper
P: Floppy Disk Drive Connector
Q: Serial Port Connector
R: Front Panel Audio Connector
S: CD-In Connector
T: PCI Slot 32-bit
U: Chassis Intrusion Connector
V: PCI Express x1 and x16 Slot
W: Rear I/O Connectors
VIG610M Motherboard Manual
14