Table of Contents
Advertisement
Front USB Connector: JUSB1~2
These connectors are for USB2.0 ports. Connect the USB module cable to any of
these connectors, and then install the module to a slot opening at the back of the
system chassis. These USB connectors comply with USB 2.0 specification that
supports up to 480 Mbps connection speed.
Table 11: Front USB connector (JUSB1~2)
Note:
The pins of VCC and GND must be connected correctly to avoid possible damage
Serial Port Connector: JCOM1
This connector is a 16550A high speed communication port that sends/receives 16
bytes FIFOs. You can attach a serial device.
Table 12: Serial Port connector (JCOM1)
V1.0
Figure 17: Front USB Connector
Figure 18: Serial Port Connector
VIG610M Motherboard Manual
28
Advertisement
Table of Contents
