Viglen VIG610M Manual page 58

Restore On AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt
occurs. Settings are:
 [Off] Always leaves the computer in the power off state.
 [On] Always leaves the computer in the power on state.
 [Last State] Restores the system to the status before power failure or interrupt
occurred.
Wakeup Event Setup
Press <Enter> and the following sub-menu will appear.
 Resume From S3 By USB Device
The item allows the activity of the USB device to wake up the system from S3
(Suspend to RAM) sleep state.
 Resume From S3 By PS/2 Keyboard
This setting determines whether the system will be awakened from what
power saving modes when input signal of the PS/2 keyboard is detected.
 Resume From S3 By PS/2 Mouse
This setting determines whether the system will be awakened from what
power saving modes when input signal of the PS/2 mouse is detected.
 Resume by PCI Device (PME#)
When set to [Enabled], the feature allows your system to be awakened from
the power saving modes through any event on PME (Power Management
Event).
 Resume by PCI-E Device
When set to [Enabled], the feature allows your system to be awakened from
the power saving modes through any event on PCIE device.
 Resume by RTC Alarm
The field is used to enable or disable the feature of booting up the system on
a scheduled time/date.
V1.0 VIG610M Motherboard Manual
57