Table of Contents
Advertisement
ADJUST ODT Strength
This feature is designed to improve the signal integrity of the memory
channel. ODT (On-Die termination) allows a DRAM to adjust the termination
resistance for each DQ and DQS/DQS# signal.
ADJUST SCOMP Strength
SCOMP (Secure Communications Processor) hardware protections against
DMA devices that allow it to move the corresponding device drivers from the
base layer to less critical parts of the system.
FSB/Memory Ratio
This item will allow you to adjust the FSB/Ratio of the memory.
Adjusted DRAM Frequency
It shows the adjusted DDR Memory frequency. Read-only.
Adjust PCI-E Frequency (MHz)
This field allows you to select the PCIE frequency (in MHz).
Auto Disable DIMM/PCI Frequency
When set to [Enabled], the system will remove (turn off) clocks from empty DIMM
and PCI slots to minimize the electromagnetic interference (EMI).
Spread Spectrum
When the motherboard's clock generator pulses, the extreme values (spikes) of the
pulses create EMI (Electromagnetic Interference). The Spread Spectrum function
reduces the EMI generated by modulating the pulses so that the spikes of the pulses
are reduced to flatter curves. If you do not have any EMI problem, leave the setting
at Disabled for optimal system stability and performance. But if you are plagued by
EMI, set to Enabled for EMI reduction. Remember to disable Spread Spectrum if you
are overclocking because even a slight jitter can introduce a temporary boost in
clock speed which may just cause your overclocked processor to lock up.
V1.0
VIG610M Motherboard Manual
61
Advertisement
Table of Contents
