Viglen VIG610M Manual page 12

 Keyboard and mouse controller:
o Industry standard 8042A compatible.
o General-purpose microcontroller.
o 8-bit internal data bus.
 ISA Plug-and-Play compatible register set.
 PCI PME interface.
 Intelligent auto power management:
o Shadowed write-only registers for ACPI compliance.
o Programmable wake up event interface.
By default, the I/O controller interfaces are automatically configured during boot up.
The I/O controller can also be manually configured in the Setup program
Serial Ports
The serial port is a 16550A high speed communications port that sends/ receives 16
bytes FIFOs. You can attach a serial mouse or other serial devices directly to the
connector.
Parallel Port
The connector for the multimode bidirectional parallel port is a 25-pin D-Sub
connector located on the back panel. In the Setup program, the parallel port can be
configured for the following:
 Compatible (standard mode).
 Bidirectional (PS/2 compatible).
 Extended Parallel Port (EPP).
 Enhanced Capabilities Port (ECP).
Floppy Controller
The I/O controller is software compatible with the N82077 floppy drive controllers
and supports both PC-AT and PS/2 modes. In the Setup program, the floppy
interface can be configured for the following floppy drive capacities and sizes:
 360 KB, 5.25-inch
 1.2 MB, 5.25-inch
 720 KB, 3.5-inch
 1.44MB, 3.5 inch
 1.2 MB, 3.5-inch (driver required)
 2.88 MB, 3.5-inch
V1.0 VIG610M Motherboard Manual
.
11