Standalone Operation Of The Rcm4000 - Digi RabbitCore RCM4000 User Manual

A program "runs" in either mode, but can only be downloaded and debugged when the
RCM4000 is in the Program Mode.
Refer to the
Rabbit 4000 Microprocessor User's Manual
gramming port.

4.3.2 Standalone Operation of the RCM4000

Once the RCM4000 has been programmed successfully, remove the programming cable
from the programming connector and reset the RCM4000. The RCM4000 may be reset by
cycling, the power off/on or by pressing the
RCM4000 module may now be removed from the Prototyping Board for end-use installa-
tion.
CAUTION: Power to the Prototyping Board or other boards should be disconnected
when removing or installing your RCM4000 module to protect against inadvertent
shorts across the pins or damage to the RCM4000 if the pins are not plugged in cor-
rectly. Do not reapply power until you have verified that the RCM4000 module is
plugged in correctly.
User's Manual
for more information on the pro-
RESET button on the Prototyping Board. The
39