Module Operation For Programmable Variant - Digi XBEE PRO S2C Manual

® ®
XBee /XBee‐PRO ZB RF Modules
PCB Layer 2 of RF Layout Example

Module Operation for Programmable Variant

The modules with the programmable option have a secondary processor with 32k of flash and 2k of RAM. This
allows module integrators to put custom code on the XBee module to fit their own unique needs. The DIN,
DOUT, RTS, CTS, and RESET lines are intercepted by the secondary processor to allow it to be in control of the
data transmitted and received. All other lines are in parallel and can be controlled by either the EM357 or the
MC9SO8QE micro (see Block Diagram for details). The EM357 by default has control of certain lines. These
lines can be released by the EM357 by sending the proper command(s) to disable the desired DIO line(s) (see
XBee Command Reference Tables).
In order for the secondary processor to sample with ADCs, the XBee pin 27 (VREF) must be connected to a
reference voltage.
Digi provides a bootloader that can take care of programming the processor over the air or through the serial
interface. This means that over the air updates can be supported through an XMODEM protocol. The processor
can also be programmed and debugged through a one wire interface BKGD (Pin 9).
© 2014 Digi International Inc. 17