Table of Contents
Advertisement
New Construction
Remote Handset Wall Holder
Wall Switch
Trim with Barrier Screen
(required)
Wall Finish
Note: Only non-combustible
fi nishes allowed over top of
cement board
Optional Hearth
Combustible material
allowed if fl ush with or below
base of appliance
Combustible Floor
allowed if fl ush with or below
base of appliance
WARNING
SAFETY WARNING! The H3 is a very effective radiant heater.
HOT WALL SURFACES! The wall directly above the fireplace is constructed of non-combustible
materials and, although safe, it may reach temperatures in excess of 200° F depending on
choice of trims. Do not touch. Finish the wall using materials suitable for these temperatures.
HEARTH/FLOOR SURFACES! The hearth/floor in front of the heater can get very hot. Locating
the unit raised above the hearth/floor and using the screen front will help reduce hearth
temperatures. Note that some materials, although safe can degrade due to heat—take this
into consideration when choosing materials.
12
Note: This appliance may be installed in outdoor, weather protected
environments as defi ned in the GV60CKO Outdoor Conversion Kit
instruction manual.
Framing
Mantel
1/2 inch thick non-combustible board or
equivalent – NOT supplied
Supplied with top outlet, fi eld convertible
to rear outlet
Combustible Framing Allowed Beneath Fireplace.
Do not install appliance directly on carpet.
Overview
Optional 4" Ø HeatShift
1000K heater
duct outlets (4). Refer to
Appendix D _ HeatShift
Advertisement
Table of Contents
