Table of Contents
Advertisement
To Set up WAN Service for ETH Interface
Three Internet connections: PPP over Ethernet (PPPoE), IP over Ethernet (IPoE) and Bridging are available in the
Ethernet uplink mode.
If you selected and configured the ETH Interface (Ethernet uplink), follow steps below to configure the WAN service:
PPP over Ethernet (PPPoE)
IPv4
Step 1: Click Advanced Setup > WAN Service and then click the Add button.
Step 2: Select the ETH interface you added just now from the pull-down menu in the figure below. Click Next.
Step 3: Select PPP over Ethernet. Edit the Enter Service Description. This field is optional. It is recommended that
you keep the default. Select a network protocol: IPv4 Only. And click Next.
59
Advertisement
Table of Contents
