Tenda I-WL-D305 User Manual page 128

b. If you select Enable(Scan) in Bridge Action field:

Select the SSID of Router 1 (Tenda_112252) in Remote Bridges MAC Address field. If you cannot find the
SSID on the list, click Refresh to refresh the list.

Then click Apply/Save to save your settings.
After you fininsh the settings on Router 2 above, do as follows:
①
Configure Router 1:
②
Click Advanced > Wireless > Wireless Bridge.
Select Access Point in AP Mode field. (If you select Wireless Bridge here, the wireless devices will not be
able to connect Router 1 wirelessly.)
If AP Mode of Router 2 is Access Point, there are two ways to bridge Router 2.
a. If you select Enable in Bridge Action field:

Enter the MAC address of Router 2 which you can check on Wireless > Basic interface, say BSSID
(02:10:18:01:00:02).
123