Tenda I-WL-D305 User Manual page 32

Step 4: Finish PPP Username and Password and other settings on the figure below. Click Next.
PPP Username/Password: For logging in to your ISP. If you cannot locate this information, ask your ISP to provide it.
PPPoE Service Name: Provided by your ISP. Only enter it if instructed by your ISP.
Authentication Method: Used by ISP to authenticate the client that attempts to connect. If you are not sure, consult
your ISP or select AUTO.
MAC Clone: When you cannot access the Internet after finishing other settings here except this option, consider
whether it's the matter of the MAC address of your computer. Clicking Clone MAC button copies the MAC address of
your computer to the router.
MTU Keep the default value unless you are sure it is necessary for your ISP connection.
:
Dial on demand: Connect to ISP only when there is traffic transmission. This saves your broadband Internet service bill.
PPP IP extension: If enabled, all the IP addresses in outgoing packets including management packets on the WAN port
will be changed to the device's WAN IP address. Only change the default settings if necessary.
Enable PPP Debug Mode: Only enable this feature if supported by your ISP.
Bridge PPPoE Frames Between WAN and Local Ports: If enabled, PPPoE dialup frame from LAN side will directly
egress the WAN port without modification.
Multicast Proxy: If enabled, the router will use multicast proxy.

KNOWLEDGE EXPANSION
1. MAC Clone: Many broadband ISPs restrict access by allowing traffic only from the MAC address of your broadband
modem, but some ISPs additionally register the MAC address of your computer when your account is first opened. If so,
only by cloning the MAC address of your computer can you access the Internet through the router.
2. MTU Short for Maximum Transmission Unit, the largest physical packet size, measured in bytes, which
:
27