Starting The Data Logger Using Cont; Starting The Data Logger Using Start - Endress+Hauser Liquiline To Go Ex CYM291 Operating Instructions Manual

Data Logger

Starting the Data Logger using CONT

Prerequisite: Data logger is configured. Every time the meter has been switched off,
the data logger must be restarted (exception: SHOT).
Measurement
Measured value is maintained
Logger: CONT blinks
Address of the last recorded value
+ 1 blinks
(proposed start address)
The measured value is saved to the selected start address (exception: SHOT).
"... FREE MEMORY" is displayed.
"LOGGER" and "active logger type" icons are displayed.

Starting the Data Logger using START

Prerequisite: Data logger is configured. All existing entries are deleted.
The start address for saving the values is 0001. Every time the meter has been
switched off, the data logger must be restarted (exception: SHOT).
Measurement
Measured value is maintained
Logger: CONT blinks
t
Logger: START blinks
All entries will be deleted. "5000 FREE MEMORY" is displayed.
"LOGGER" and "active logger type" icons are displayed.
pH
If desired: Select start address using st.
37
Oxy Cond