Table of Contents
Advertisement
18
Cond
Configuration (Cond)
Configuration is required to match the connected sensor and the
desired measurement performance. Furthermore, you can select the
suitable calibration method. The following table gives you an over-
view. Factory settings are shown in bold print.
Measurement
"Setup" display
Display
MOHM cm
Cond Unit
TDS Factor
TC *
TC LINEAR
REF. Temp.
s
t
CAL
Auto OFF
Temp. Unit
Time Format
Date Format
Default
This icon prompts you to select a menu item using the arrow keys –
s
the selection is confirmed by pressing .
t
* Temperature compensation
Select using arrow keys, confirm by pressing .
Cond | SAL g/kg | TDS mg/l
OFF | On
mS/cm | S/m
0.0 ... 1.0 (if display = TDS)
OFF | LINEAR | NLF | NACL | HCL | NH3 | NAOH
(if display = Cond)
0.0 ... 20.0 %/K | 2.1 %/K (if TC = LINEAR)
0 ... 100 °C | 25 °C
(if TC = LINEAR)
CELL CONST. | COND | <25°C> 74.0µS/cm |
<25°C> 149.6µS/cm | <25°C> 1.406mS/cm |
<25°C> 12.64mS/cm | <25°C> 107.00mS/cm |FREE CAL
OFF | 0.1h | 1h | 6h | 12h
°C | °F
24h | 12h
dd.mm.yy | mm.dd.yy
NO | YES (reset to factory settings)
Note: All data logger entries will be deleted.
Configuring
( 32 ... 212 °F | 77 °F)
Advertisement
Table of Contents
