Table of Contents
Advertisement
Measuring
Once you have completed all preparations, you can start with
the actual measurement.
1) Connect the desired sensor to the meter. Some sensors
require a special preparation. Please proceed according to
the operating instructions for the sensor.
2) Switch the device on using the
3) Depending on the measurement method and the sensor
used, immerse the sensing part of the sensor in the medium
to be measured.
4) Watch the display and wait for the reading to stabilize.
5) By pressing the
value (see data logger, page 32).
Toggling the Measured Value Display
During measurement, you can toggle the measured value
display by pressing
• pH: between pH and mV
• Cond: between compensated and uncompensated
measured value (when temperature compensation, SAL or
TDS are activated)
• Oxy: not applicable
Adjusting the Temperature
When you connect a sensor without temperature detector,
you can manually adjust the temperature for measurement or
calibration:
1) Press
to access measuring mode.
The adjusted temperature will be displayed.
2) Set the desired temperature value using the or arrow.
Holding the key depressed changes the temperature value
at high speed.
or
key, you can hold and save a measured
:
pH
key.
31
Oxy Cond
Keys for
measurement
Advertisement
Table of Contents
