Function Description - Philio PST07 Manual

Add to/Remove from Z-Wave
There are two tamper keys in the device, one is in the back side,
another is in the front side. Both of them can add, remove, reset or
association from Z-Wave TM network.
The table below lists an operation summary of basic Z-Wave functions.
Please refer
to the instructions for your Z-WaveTM Certificated Primary Controller to
access the
Setup function, and to Add/Remove/associate devices
Notice: Including a node ID allocated by Z-Wave
"Add" or "Inclusion". Excluding a node ID allocated by Z-Wave
Controller means "Remove" or "Exclusion".
Description
Function
1. Have Z-Wave
2. Pressing tamper key three times within 2 seconds
to enter the inclusion mode.
Add
3. After add successful, the device will wake to
receive the setting command from Z-Wave
Controller about 20 seconds.
1. Have Z-Wave
2. Pressing tamper key three times within 2 seconds
Remove
to enter the exclusion mode.
Node ID has been excluded.
TM Network
TM Controller means
TM Controller entered inclusion mode.
TM Controller entered exclusion mode.
Reset
SmartStart
TM
Association
TM
Failed or success in add/remove the node ID can be viewed
•
from Z-Wave
3
Notice: Use this procedure only in the event
that the primary controller is lost or
otherwise inoperable.
1. Pressing button four times and keep about 5
seconds.
2. IDs are excluded and all settings will reset to
factory default.
1. Product has a DSK string, you can key in first five
digit to increment smart start process, or you can
scan QR code.
2. SmartStart enabled products can be added into a
Z-Wave network by scanning the Z-Wave QR Code
present on the product with a controller providing
SmartStart inclusion. No further action is required
and the SmartStart product will be added automati-
cally within 10 minutes of being switched on in the
network vicinity.
*notice1:The QR code can be found on the device
or in the box.
3. Have Z-Wave TM Controller entered association
mode.
4. Pressing tamper key three times within 1.5 seconds
to enter the association mode.
Note: The device support 2 groups. The group 1 is for
receiving the report message, like triggered event,
temperature, illumination etc. The group 2 is for light
control, the device will send the "Basic Set" command
to this group. A group one support 1 nodes maximum
and group two support 5 nodes maximum.
TM Controller.