Philio PAD02 Quick Start Manual

PAD02
Z-Wave Smart Dimmer Socket
PAD02 is an E27(EU)/ E26(US) Edison screw based lamp socket, which provides
electrical connection to the E14(EU)/ E12(US) Edison screw based lamps and
support it in the lighting fixture. The use of socket allows lamps to be safely and
conveniently replaced. You can On/Off the light by pressing the button briefly,
or a long pressing to control the brightness of dimmable lightbulb.
This dimmer is a transceiver which is a security enabled device which based on
Z-Wave Plus technology. Z-Wave Plus
TM
Plus logo can also be used with it regardless of the manufacturer, and can also be
used in other manufacturer's Z- Wave
of the connected light is possible with other manufacturer's wireless Controller.
Since PAD02 supports Security Command Class, it can learn with a Secured enabled
controller to fully utilize the device.
identical when included as a secure and non-secure device.
TM
Adding to Z- Wave Network
In the front casing, there is an on/off button with LED indicator below which is used to
TM
enabled devices displaying the Z-Wave
TM
enabled networks. Remote dim level control
Its functionality and supported command classes is
switch on and off, dim level, or carries out add, remove, reset or association.
When first power is applied, its LED flashes on and off alternately and repeatedly at
0.5 second intervals. It implies that it has not been assigned a node ID and start auto
inclusion.
Auto Inclusion
The function of auto inclusion will be executed as long as the dimmer does not
have Node ID and just connect the dimmer to main power.
Note: Auto inclusion timeout is 2 minute during which the node information of explorer
frame will be emitted once every several seconds. Unlike "inclusion" function as
shown in the table below, the execution of auto inclusion is free from pressing the
On/Off button on the dimmer.
The table below lists an operation summary of basic Z-Wave functions. Please refer
to the instructions for your Z- Wave
setup function, and to Add/Remove/Associate devices
Function
No node ID The Z-Wave Controller does not allocate
a node ID to the Switch.
1. Put your Z-Wave controller into
Add
inclusion mode by following the
instructions provided by the
controller manufacturer.
2. Pressing Include button of PAD02
three times within 2 seconds will
enter inclusion mode.
1. Put your Z-Wave controller into
Remove
exclusion mode by following the
instructions provided by the
controller manufacturer.
1.
Pressing Include button of PAD02
three times within 2 seconds will
enter exclusion mode.
Node ID has been excluded.
1
TM
certificated primary controller to access the
Description
LED 2-second on, 2-second
off
0.5s On, 0.5s Off (Enter
auto inclusion)
Annotation