Product Description; Installation Guidelines - Philio Z-Wave PHI PSM02 Quick Start Manual

4 in 1 sensor (door-/window, pir/motion, temperature, illumination)

Table of Contents

1. Controllers control actuators

2. Actuators report change of status back to controller

3. Sensors report change of status of measured values to controller

4. Sensors directly control actuators

5. Actuators control other actuators

6. Remote controls send signals to static controllers to trigger scenes or other actions

7. Remote controls control other actuators.

There are two different role a controller can have. There is always one single primary controller that is managing the

network and including/excluding devices. The controller may have other functions - like control buttons - as well. All other

controllers don't manage the network itself but can control other devices. They are called secondary controllers. The

image also shows that its not possible to operate a sensor just from a remote control. Sensors only communicate with

static controllers.

Product description

The Z-Wave 4 in 1 Sensor is designed with three detection sensors:

Door-/Window

PIR/Motion

Temperature

Illumination

The Philio Multi Sensor is a Z-Wave door/ window sensor, motion sensor, lighting sensor and temperature

sensor in one package. Thanks to this the PSM02 can be uses as a security device or home automation

device, e.g. to send an alarm when a motion is detected, turn the light on/ off automatically at night or to

adjust the heater.

The product consists of two elements - the detector and the magnet. The magnet is mounted on the moving

part of the window or of the door. The other part is placed on the frame.

Batteries

The unit is operated by batteries. Use only batteries of correct type. Never mix old and new batteries in the

same device. Used batteries contain hazardous substances and should not be disposed of with household

waste!

Battery Type: 1 * CR123A

Table of Contents

Show Quick Links

Table of Contents