Initial Operation; Turning On The Device; Switching Off; Operation And User Guidance - Macherey-Nagel NANOCOLOR VARIO C2 Manual

10. Initial operation

10.1 Turning on the device

Connect the heating block to the power supply and switch it on with the main I / O switch
(Figure 4, No. G) located on the back of the device. The device will start up and the manufac‑
turer's logo will be displayed. After a few seconds the start screen will appear.
By pressing
software‑ as well as bootloader versions will be displayed.
The device must always be set up in such a way that the on / off switch can be operated at
any time.

10.2 Switching off

If you are not going to use the device for a longer period of time, take it out of operation and
disconnect it from the power supply.
To switch off the device, tilt the I / O switch on the back of the device (Figure 3, No. G) to the
right (O).

11. Operation and user guidance

Do not operate the touch screen with sharp or pointed objects, as this will damage the
screen.
The heating block has an illuminated, color touch screen display (Figure 4, No. A). The display
is operated by touching individual fields. Familiarize yourself with the operation of the touch
screen display by touching individual buttons with your finger or a special stylus. Touching
buttons selects the corresponding function.
Manual heating block NANOCOLOR
42
NOTICE
, the info screen will be displayed. The serial number, installed
NOTICE
NOTICE
NOTICE
VARIO C2 / VARIO 4 EN, 08.2021
®