Temperature Monitoring; Remove Cuvettes - Macherey-Nagel NANOCOLOR VARIO C2 Manual

A running program can be aborted at any time. A program abort is initiated by
pressing the
confirmed by pressing the
normally.

13.4 Temperature monitoring

When Graphic mode is activated (see chapter Graphic mode, page 44), the start screen
changes to Graphic mode (Figure 16) a few seconds after a program is started and displays
the temperature curve of the current heating process.
The temperature range can be enlarged or reduced by tapping the graphic field. Pressing the
button takes you back to the program selection. With the heating block NANOCOLOR
VARIO 4 it is possible to switch between the two sides of the heating block in the graphic
mode (see chapter Graphic mode, page 44) by pressing the
touched for some time in the program selection, the view automatically changes back to the
graphic mode.

13.5 Remove cuvettes

Danger of burns. The sample cuvettes are hot. Wear suitable protective equipment
(e.g. thermally insulating gloves). Remove the vials only when the temperature is
below 80 °C.
Risk of injury: If the cuvettes cool down quickly, there is a risk that they will break and cause
cuts. Do not cool hot vials with cold water unless specifically required. Allow the vials to cool
in the air or in the heating block.
Manual heating block NANOCOLOR
NOTICE
key. STOP appears on the display. Within 5 s, the abort must be
key again, otherwise the program will continue to run
Figure 16: Graphic mode
WARNING
WARNING
®
VARIO C2 / VARIO 4 EN, 08.2021
key. If the display is not
®
51