Setting Up And Connecting The Device - Macherey-Nagel NANOCOLOR VARIO C2 Manual

8. Setting up and connecting the device

Risk of burns: The safety cover(s) must be installed to prevent personal injury. The
safety cover prevents burns. Always keep the protective cover(s) closed during
operation.
Risk of electric shock: The safety cover(s) must be installed to prevent personal injury.
The safety cover prevents damage to the power cord. Always keep the protective
cover(s) closed during operation.
Risk of injury due to the danger of tipping over due to slipping. Place the device on a flat
surface. Do not stack the appliance. Set up the unit in a laboratory or similar environment
(recommended location: fume hood).
Only place the device in a designated location. Make sure that the surface is dry, clean, level
and horizontal to avoid overheating the unit. If possible, set up the unit on a flame‑retardant
surface (e.g. laboratory bench).
Damage due to condensation and exceeding the temperature limits:
The device is designed for indoor use only. Operate the device in a clean and dry
environment.
Take care not to overload the mains socket. There is a risk of overload and fire. Make sure
that the power cord is not damaged. Check the suitability of the power source used for the
equipment.
Risk of injury: Familiarize yourself with the device before working with it and read this
document carefully. Do not use the device unless you have received instruction in its use.
Defects at the power supply and housing can lead to malfunction of the device. If the device
shows an apparent breakage of the housing or a damaged power supply, it must be taken
out of operation.
Manual heating block NANOCOLOR
WARNING
DANGER
CAUTION
NOTICE
NOTICE
WARNING
WARNING
NOTICE
VARIO C2 / VARIO 4 EN, 08.2021
®
39