Table of Contents
Advertisement
P5
P6
P7
P8
G+
G-
SPEED_LED
Y-
LINK_LED
Y+
Appendix 5 operation guide for label loading under peel-off mode (optional)
When using labels with adhesive, the user can refer to "2.4 Installing paper roll" for installation, and the paper
out mode can be set to peel-off mode. When peel-off mode is selected, follow the steps below to load labels:
1) Remove several labels on the front of label base paper, ensure the first label is flush, and pull the peel-off
turn board outward (see figure appendix 5-1);
2) Pass the label base paper through the peel-off module according to the path shown in the figure (see figure
appendix 5-2);
Label
Base paper
Peel-off turn board
Paper existence senor
Peel-off latch
3) Push the peel-off turn board back into place and keep the base paper in tension state to end label loading.
4) When the printer is working, it peels labels off the base paper and sends each label out one by one. After
the user takes the label away from the printer, the printer will continue to execute the next command.
Reserve
RX-
Reserve
Reserve
VCC
VCC
Table appendix 4.4-1 Ethernet signal list
Figure appendix 5-1
——
Input -
——
——
power
output
output
power
Figure appendix 5-2
- 26 -
Z5
User's Guide
DT
——
Difference data signal input-
——
——
SPEED_LED power
SPEED LED signal
LINK LED signal
LINK_LED power
Peel-off bar
Print platen roller
Peel-off platen roller
Peel-off turn board
Label base paper
Advertisement
Table of Contents
