AMT Datasouth Fastmark Z5DT Series User Manual page 3

Safety Instructions
Before installing and using the printer, please read the following items carefully.
1． Safety warning
The print head is a thermal element and it is at a high temperature during printing or just after operation,
therefore do not touch it or its peripherals for safety's sake
The print head is an ESD-sensitive device. To prevent damage, do not touch either its printing parts or
connecting parts.
2． Notices
1) Install the printer on a flat and stable surface;
2)
Reserve adequate space around the printer so that convenient operation and maintenance can be
performed;
3) Keep the printer far away from water source, and do not expose the printer to direct sunlight, strong light
and heat;
4)
Do not use or store the printer in a place exposed to high temperature, high humidity or serious pollution;
5)
Do not place the printer in a place exposed to vibration or impact;
6) No condensation is allowed to the printer. In case of such condensation, do not turn on the power until
it has completely gone away;
7)
Connect the printer power to an appropriate grounding outlet. Avoid sharing one electrical outlet with
large power motors or other devices that may cause the fluctuation of voltage;
8) Disconnect the power when the printer is deemed to idle for a long time;
Don't spill water or other electric materials into the printer (e.g. metal). In case this happens, turn off the
9)
power immediately;
10)
Do not allow the printer to start printing when there is no media installed; otherwise the print head and
platen roller will be damaged;
11) To ensure quality print and normal lifetime, use recommended labels and paper or its equivalent;
12)
Shut down the printer when connecting or disconnecting interfaces to avoid damages to control board;
13)
Set the print darkness to a lower grade as long as the print quality is acceptable. This will help to keep
the print head durable;
14) Avoid turning on and off the printer frequently. It is advised to turn on the printer at least 2 seconds after
the printer is turned off;
15)
Do not disassemble the printer without permission of a technician, even for repairing purpose;
16)
Retain this manual for reference purpose.
.
Z5 User's Guide
DT