Table of Contents
Advertisement
INSTALLATION
All the "left", "rght", "front" and "rear"
desgnatons n ths manual are as vewed by
the operator facng the machne controls on
the electrcal control box.
LOCATION
1.
The floor area required by the standard machine is
approximately 59.50 inches (1511.3 mm) in width
by 44.50 inches (1130.3 mm) in length. Machine
height for the machine approximately is 84.50
inches (2146.3 mm). Refer to pages 1 and 2 for
further machine dimensions.
2.
Locate the machine to provide adequate space for
your sawing needs. Be sure to provide sufficient
clearance for: (a) Material loading and unloading; (b)
All door openings; (c) Maintenance and lubrication
procedures; (d) Operation of the any supplied
machine accessories.
OSHA NOTICE!!
OSHA Regulaton 1910.212 (5B).
Machines designed for a fixed location shall
be securely anchored to prevent walkng or
movng.
UNPACKING
1.
The machine is fastened to and shipped on a wooden
skid. Overseas shipments are also crated.
2.
Carefully remove all protective covers, strapping,
hold-down brackets, crating, etc. Then: (a) Remove
all bolts which fasten the machine to the shipping
skid; (b) Check inside the rear drive compartment
for other removable brackets, extra machine parts
or supplies which might have been placed there for
shipment. (c) Inspect the machine and all parts for
shipping damage. Claim procedures are listed on
this manual's inside front cover.
CLEANING
1.
If necessary, use solvent to remove rust-preventive
coating applied to exposed bare metal surfaces
before shipment.
LIFTING
1.
A tapped hole is located on top of the machine's saw
head. Screw a forged 3/4-10NC eye-bolt into this
hole for lifting purposes. Net weight of the machine
is approximately 1800 pounds (816.5 kg).
DO NOT lft the machne by ts sawng head.
MACHINE INSTALLATION and ALIGNMENT
1.
To properly align the machine, place shims between
the floor and the base mounting pads until the
machine is level with weight resting evenly on all
the base pads.
Shim Locations.
2.
Square the worktable to the side of the post by
loosening the tilt lock bolt located in the machine's
frame under the worktable and make the necessary
adjustments.
worktable's tilt angle pointer at zero (0) on the tilt
scale; (b) Tighten the tilt lock bolt.
Squaring Worktable to Post.
If necessary:
(a) Position the
Advertisement
Table of Contents
