Installation; Location; Osha Notice; Unpacking - DoAll ZV-3620 Instruction Manual

INSTALLATION

All the "left", "right", "front" and "rear"
designations in this manual are as viewed by
the operator facing the machine's pushbutton
controls.

LOCATION

1. The floor area required for the standard machine is
approximately 81.50 inches (2070.1 mm) in width
by 36.25 inches (920.8 mm) in length. Machine
height for the standard machine is 103.25 inches
(2622.6 mm). Optional tables may require extra
space. Refer to pages 1 thru 4 for further machine
dimensions.
2. Locate the machine to provide adequate space
for your sawing needs. Be sure also to provide
sufficient clearance for: (a) Loading and unloading
of stock; (b) All door openings; (c) Maintenance and
lubrication procedures; (d) Plus any operation of
any machine options, if applicable.

OSHA NOTICE!!

OSHA Regulation 1910.212 (5B).
Machines designed for a fixed location shall
be securely anchored to prevent walking or
moving.

UNPACKING

1. In most cases, the machine is fastened to and
shipped on a wooden skid and shipped on its
side.
2. If shipped on its side, tip the machine upright first
before removing any other shipping materials.
3. Carefully remove all protective covers, strapping,
hold-down brackets, crating, etc. Then: (a) Remove
all bolts which fasten the machine to the shipping
skid; (b) Check for other removable brackets, extra
machine parts or supplies which might have been
placed for shipment; (c) DO NOT remove the motor
blocking until the machine is placed in desired
position; (d) Inspect the machine and all parts for
shipping damage. Claim procedures are listed on
this manual's inside front cover.

CLEANING

1. If necessary, use solvent to remove any rust-
preventive coating applied to exposed bare metal
surfaces before shipment.

LIFTING

1. A tapped hole is located on top of the machine's
column. Screw a forged 3/4-10NC eye-bolt into
this hole for lifting purposes. An overhead hoist
is recommended. The weight of the machine is
approximately 3500 pounds (1587.6 kg).
DO NOT lift the machine by the sawing
head.
2. Lifting of the HMD hydraulic table can be done by
a fork lift or overhead hoist. Distribute the weight
evenly when lifting. Approximate weight of the table
is 1500 pounds (680.4 kg).

MACHINE INSTALLATION and ALIGNMENT

Drive Motor Installation (When Machine Was Shipped
On Its Side)
1. Install the two (2) motor supports. The supports
have been correctly aligned and doweled at the
factory. Then: (a) Slip in the motor base weldment
into the supports and install cotter pins; (b) Place
the belts around both motor and spindle pulleys; (c)
Adjust the belt tension screw so very little deflection
is noticed; (d) Install the belt guard to the machine
frame.
Drive Assembly.
DO NOT change the location of the motor
or spindle pulley as they have been factory
aligned.
9