Installation; Location; Osha Notice; Unpacking - DoAll 3613-V5 Instruction Manual

INSTALLATION

All the "left", "rght", "front" and "rear"
desgnatons n ths manual are as vewed by
the operator facng the machne's electrcal
controls.

LOCATION

1. The floor area required by the standard machine is
approximately 73.88 inches (1876.6 mm) in width by
42.88 inches (1089.2 mm) in length. Machine height
for the standard machine is 79.88 inches (2029.0
mm). Refer to pages 1 & 2 for further machine
dimensions.
2. Locate the machine to provide adequate space
for your sawing needs. Be sure also to provide
sufficient clearance for loading and unloading of
stock, post elevation, door opening, maintenance
and lubrication procedures, plus operation of any
machine accessories.

OSHA NOTICE!!

OSHA Regulaton 1910.212 (5B).
Machines designed for a fixed location shall
be securely anchored to prevent walkng or
movng.

UNPACKING

1. The machine is fastened to and shipped on a wooden
skid. Overseas shipments are also crated.
2. Carefully remove all protective covers, strapping,
hold-down brackets, crating, etc. Then: (a) Remove
all bolts which fasten the machine to the shipping
skid; (b) Check inside the rear drive compartment
for other removable brackets, extra machine parts
or supplies which might have been placed there for
shipment; (c) Inspect the machine and all parts for
shipping damage. Claim procedures are listed on
this manual's inside front cover.

CLEANING

1. If necessary, use solvent to remove rust-preventive
coating applied to exposed bare metal surfaces
before shipment.

LIFTING

1. A tapped hole is located on top of the machine's
saw head. Screw a forged 3/4-10NC eye-bolt into
this hole for lifting purposes. Gross weight of the
machine is approximately 1850 pounds (839.2
kg).
DO NOT lft the machne by ts sawng head.

MACHINE ALIGNMENT

1. Place shims between the floor and the base mounting
pads until the machine weight is resting evenly on
all the base pads.
Typical Shim Locations.
2. Place a good quality, 10 inch (254.0 mm) master
square on the worktable against the post's back side.
Measure clearance between the post and square
near the bottom of the post. Clearance should be
within 0.007-inch ±0.005-inch (0.18 mm ±0.13 mm)
at the bottom of the post for standard machines.
Squaring Worktable to Post.
5