Table of Contents
Advertisement
Close monitor: Click the icon
on the top right corner of the monitor to close one monitor, or click
the shortcut
on the right side of the interface to close all monitors.
Reset monitor: User can reset the monitor by clicking the shortcut
on the right side of the
interface.
Swap monitor: Users can swap the monitor by clicking the shortcut
on the right side of the
interface, as shown in the figure below.
Auto tile: User can enable or disable the auto tile function by clicking the auto tile shortcut
on
the right side of the interface. If select auto tile "ON', the layer will automatically snap to the output grid
when move the layer to the position within the threshold value.
Monitor Size and Position Setting: Move the mouse to the lower right brink of the monitor, and press
the left key of the mouse. Move the mouse to the suitable position and release the mouse. But this
method can only adjust the size and location roughly, if an accurate adjustment is needed, select the
monitor, and set the X, Y, width and height in the bottom of the interface.
Monitor Size changed equivalently: Select any monitor, for example, select monitor 1, and adjust the
size. Click this monitor, then press button C and don't let go, select the monitor that will set, the size of
the selected monitor will be changed to the same size of monitor 1, as shown in the figure below:
© Xiamen RGBlink Science & Technology Co., Ltd.
28 / 51
Ph: +86 592 5771197 |
support@rgblink.com
|
www.rgblink.com
Advertisement
Table of Contents
