Connect With The Device - RGBlink X3p Quick Start Manual

Connect with the device

Connect the PC which XPOSE software runs on with CAT5 cable to the X3.
Power on X3 and ready to make the remote set up and configuration.
Set up the IP of the computer, and make sure the IP of the computer and the X3 are on the same
network range but not the exact same IP address. IP address of X3 device is shown on the OLED
screen after X3 is power on.
Then, click the shortcut "Search" on the operation interface.
Then it will search the X3, and show the device name, device number and IP after search, as shown in
the figure below:
© Xiamen RGBlink Science & Technology Co., Ltd.
10 / 51
Ph: +86 592 5771197 | support@rgblink.com | www.rgblink.com