RGBlink X3p Quick Start Manual page 30

Rotation: Select the monitor, and set the rotation as 0°, 90°, 180° and 270° in the bottom of the
interface. Click "OK" to confirm. As shown in the figure below:
Right click the monitor can also rotate the monitor, and each output module can only swap one output.
Output Area Size Setting: Move the mouse to the output area and slide the mouse wheel, the output
area size can be zoom in and out. When zoom out the output area, press the wheel of the mouse will
drag the whole operation area.
Layer Setting
New Layer: In output screen zone of controlling software, press the left mouse key and drag on the
intended output screen to cover the whole current screen. And the below interface will be displayed.
Input signal can be changed by double clicking the left signal source to be shown on the window.
Adjust Layer: Two ways can change the size and location of the opened layer:
a. Drag the opened layer by mouse. The details are: move the mouse to the brink of the opened layer,
when the mouse shows"<—>", press the left key of the mouse and drag the window to a suitable size
and then release the mouse. Or move the mouse to the lower right of the opened layer, press the left
key of the mouse and drag the window to a suitable size and then release the mouse. Move the mouse
to the opened layer and press the left key of the mouse and move the mouse, then the layer will be
moved, release the mouse when moved to the suitable location. But this method can only adjust the
size and location roughly, if an accurate adjustment is needed, the second method can be used.
b. Select the layer to be adjusted, and set the X, Y, width and height in the bottom of the interface.
Hierarchical relations between layers: After creating the layers, the hierarchical relations can be
changed by the following: click the shortcut key bring layer to top " ", bring layer to bottom " ",
layer forward " " or layer backward " ". The layer can be set as background by click " "
and click " " to remove the layer background.
Close one layer or all layers: Click the icon on the top right corner of the layer to close one layer,
or click the shortcut key " " to close all layers.
© Xiamen RGBlink Science & Technology Co., Ltd.
29 / 51
Ph: +86 592 5771197 | support@rgblink.com | www.rgblink.com