R
4 CONNECTING TO YOUR GAUGE
Connect your gauge to your printer via the 25 way D-type
socket at the rear of the printer.
Plug the Elcometer printer/gauge connection cable supplied
into the 25 way D-type socket on the printer and the socket on
the gauge (3 way for 345 models, 25 way 'D' for 355 models, 5
way for 224 and 456 Models) before switching on either the
printer or gauge. The printer is supplied setup ready to operate
with the relevant instrument as shown in the following table:
Elcometer Instrument Model
Elcometer 345
Elcometer 355
Elcometer 224 & 456
Note: The 355 connecting lead (Part No. 11837) has a 25-pin plug at both ends. The plug with the label
marked '355' should connect to the instrument.
Note: The baud rate can be changed - see page 7.
4
Connecting
Baud Rate
Cable Part
Number
1200
7667
9600
11837
9600
16267
Insert printer/gauge
connection cable
here
Insert battery
charger
cable here