Changing The Baud Rate - Elcometer 345 Operating Instructions Manual

7 CHANGING THE BAUD RATE

If you need to change the baud rate of the printer (for example, when using the printer with a different type
of gauge) refer to the table shown on page 4.
To change the baud rate setting:
1. Hold down the Set Up button and at the same time press
the On button to switch the printer on. The printer will print
out the current settings.
2. Each time the Set Up button is pressed, another
parameter will be printed.
3. When the Baud Rate setting has been printed, press the Paper Feed button until the correct setting is
printed.
4. Press both Set Up and Paper Feed buttons together to set the new Baud rate and enter that setting
into the printer memory.
Note: Do not change any of the other following settings:
Data Bits: 8
Country: UK
Auto-off: 5min
DTR: Normal
Parity: None
Print Mode: Text
Emulation: Standard
SET PAPER
UP FEED ON
R
7