Symbols Used; Intended Use; Spare Parts, Accessories And Wear Parts; Power Connectors - Bosch rexroth IndraControl XFE 01.1 Operating Manual

IndraControl XFE 01.1
3.3

Symbols used

This is a tip.
4

Intended use

NOTICE
The extension modules can be used for complex connections to controls that cannot be operated at the
S20 bus, such as interface modules to Profinet, Profibus, CAN and Sercos or Safety connection.
The extension modules may only be operated under the mounting and installation conditions, the
position, and the specified ambient conditions (temperature, degree of protection, humidity, EMC etc.)
specified in the related documentation.
5

Spare parts, accessories and wear parts

5.1 Power connectors, 24 V
Ordering code
XA-CN01
5.2

Connector set for the CAN module

Ordering code
S20-CNS 2S-O/D/UI/E1/E2
5.3

Bus base module

Ordering code
XA-BS11
R911345570, Edition 06
Risk of damaging the device if not expressly stated accessories, mounting
parts and other components, cables, lines, software and firmware are used.
The extension modules may exclusively be used with the accessories and
add-on components specified in this documentation. Components that are
not expressly mentioned must neither be attached nor connected. The same
applies to cables and lines.
Only to be operated with the component configurations and combinations
expressly defined and with the software and firmware specified in the corre-
sponding functional description.
Part number
R911173741
Part number
R911173804
Part number
R911173772
Description
24 V plug
Description
Connector set for the 24 V module and the CAN module
Description
Bus base module for extension modules
9 / 36
Bus base module
Bosch Rexroth AG