IndraControl XFE 01.1
13
Error causes and troubleshooting
13.1
Error messages of the status LEDs
For operating and error displays, refer to
⮫ Chapter 12.3 "LEDs on the XD1 plug " on page
Table 17: Voltage power connector
LED
LED display Cause
PW
LED is off
ON
LED is off
U
LED is off
L
Table 18: RT-Ethernet (Profinet, Ethernet/IP)
LED
LED display Cause
S
LED is off
L
LED is off
SF
Red
R911345570, Edition 06
⮫ Chapter 12.2 " LEDs on extension modules" on page 25
26.
Internal voltage error:
•
Voltage transformer is defective
•
24 V supply voltage is not connected
•
24 V supply voltage is connected with reverse polarity
Internally programmed function block is not loaded
24 V voltage errors:
•
24 V supply voltage is not connected
•
24 V supply voltage is connected with reverse polarity
No data is sent
No connection present
•
Master and slave:
LED flashes (1 Hz, 3 s): The DCP signal service is triggered via
the bus and it is only available for the Profinet device.
•
Master:
LED flashes (2 Hz): System error: invalid configuration, moni-
toring error or internal error
LED on (together with BF "red on"): Invalid master license
•
Slave:
LED on: Watchdog timeout; channel, generic or extended diag-
nostics present; system error
Error messages of the status LEDs
Bosch Rexroth AG
27 / 36
and