Symbols Used; In The Documentation; Warning Notices - Structure And Meaning; Symbols In This Documentation - Bosch Denoxtronic 2.1 Product Description

1.

Symbols used

1.1

In the documentation

1.1.1

Warning notices - Structure and meaning

Warning notices warn of dangers to the user or
people in the vicinity. Warning notices also indicate
the consequences of the hazard as well as preventive
action. Warning notices have the following structure:
KEY WORD – Nature and source of hazard!
Warning
symbol Consequences of hazard in the event of
failure to observe action and information
given.
¶
Hazard prevention action and information.
The key word indicates the likelihood of occurrence and
the severity of the hazard in the event of non-observance:
Key word Probability of
occurrence
DANGER Immediate impending
danger
WARNING Possible impending
danger
CAUTION Possible dangerous
situation
1.1.2

Symbols in this documentation

Symbol Designation Explanation
Attention Warns about possible property damage.
!
Information Practical hints and other
i
useful information.
1. Multi-step Instruction consisting of several steps.
2. operation
One-step Instruction consisting of one step.
e
operation
Intermediate An instruction produces a visible

result intermediate result.
Final result There is a visible final result on
"
completion of the instruction.
1.2

On the product

!
Observe all warning notices on products and ensure
they remain legible.
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
Robert Bosch GmbH
Severity of danger if
instructions not observed
Death or severe injury
Death or severe injury
Minor injury
Symbols used | Denoxtronic 2.1 | 19
2.

User instructions

2.1

Important notes

You can find relevant information on the use of
the components in the separate ESI[tronic] repair
instructions Denoxtronic 2.1 under the sections
"Safety instructions", " Repair instructions " and
"Lubricants and auxiliary materials". These must be
carefully studied prior to start-up, connection and
operation and must always be heeded.
To check for leaks by means of pressurized gases, the
tester must be certified at least to DIN EN ISO 9712
Level 1.
2.2

Safety instructions

All safety instructions can be found in the separate
ESI[tronic] repair instructions Denoxtronic 2.1 in the
section "Safety instructions". These instructions should
be carefully studied prior to start-up, connection and
operation of the diagnostic device and must always be
heeded.
2.3

Intended use

The devices and components of test sets 0 986 610 571
and 0 986 610 581 are exclusively for testing and repairing
the AdBlue supply module, type Denoxtronic 2.1.
!
Nonobservance can lead to accidents and damage.
2.4

Training

Testing and repairs of the AdBlue supply module type
Denoxtronic 2.1 may only be performed by qualified
and trained personnel. We recommend user training in
testing and repair at the the AA training center.
en
|
1 689 989 404 2019-03-01