13.1.1 Error Cases After Commissioning The Can Module - Bosch rexroth IndraControl XFE 01.1 Operating Manual

28 / 36
Error messages of the status LEDs
LED LED display Cause
BF Red
During normal mode (without errors), the LEDs "SF" and "BF" can also be on, but at low
intensity. This does not signal an error state. Check, whether additional diagnostic information
in available in the diagnostic log.
Table 19: Profibus
LED LED display Cause
Stat LED is acycli-
cally on
BF LED is perma-
nently on
LED flashes Slave diagnostics
Table 20: Sercos
LED LED display Cause
S LED is off
L LED is off
Table 21: CAN
LED LED display Cause
PW LED is off
ERR LED is red
RUN LED is off

13.1.1 Error cases after commissioning the CAN module

The following errors can be displayed when commissioning the CAN module, also refer to
⮫ Chapter 11.1 "Commissioning notes " on page
Bosch Rexroth AG
•
Master:
LED flashes (2 Hz): Configuration error: Not all configured I/O
devices are connected
LED on (together with SF "red on"): Hardware problem, field
bus stack cannot be loaded or there is no valid master license.
LED on (together with SF "red on"): No link, double IP, Hidden
Loop
•
Slave:
LED flashes (2 Hz): No data exchange
LED on: No configuration or slow physical connection, no phys-
ical connection or double IP
Module not configured
No connection
No data is sent
No connection present
Voltage error of the CAN voltage
Bus error, refer to the CANopen standard "CIA 303 Part 3: Indicator
Specification"
Communication error, refer to the CANopen standard "CIA 303 Part
3: Indicator Specification"
24:
IndraControl XFE 01.1
R911345570, Edition 06