10.3.1 Mounting Extension Bus Base Modules - Bosch rexroth IndraControl XFE 01.1 Operating Manual

IndraControl XFE 01.1
Fig. 8: Positioning and removing modules only vertically
NOTICE
The extension bus base modules can only be mounted if the control is not attached to the
control bus base module.

10.3.1 Mounting extension bus base modules

1. Press the extension bus base modules for the extension modules on the top-hat rail on the left
next to the control bus base module until all latchings are safely closed (see (A) in the following
figure).
2. Move the first extension bus base module (see (B) to the right and connect the extension bus
base module with the bus base module of the control (see (D) in the following figure).
3. Move the other extension bus base modules to the right until all bus base modules are connected
to each other (see (C) in the following figure).
4. Fit the extension modules and the XMx control on the bus bases.
R911345570, Edition 06
Destruction of components and devices due to mounting and dismounting
under voltage!
−
Before mounting or dismounting, disconnect the control - including its
components - from voltage.
−
Connect the voltage only after the control and its components have been
set up.
19 / 36
Mounting
Bosch Rexroth AG