Table of Contents
Advertisement
To bypass Setup Password:
If you forget your setup password, you can bypass the password
security feature by hardware.
password:
1.
Turn off and unplug the computer.
2.
Open the computer housing and set JP4 to 2-3 (Bypass
password) to bypass the password function. See section 1.4 for
the location of JP4.
3.
Turn on the system and enter the BIOS utility. This time, the
system does not require you to type in a password.
You can either change the existing Setup
password or remove it by selecting
Refer to the previous section for the procedure.
2.8.2
Power-on Password
The Power-on Password secures your system against unauthorized
use. Once you set this password, you have to type it whenever you
boot the system. To set this password, enter the Setup Utility, select
System Security, and then highlight the Power-on Password
parameter.
Follow the same procedure as in setting the Setup
password.
Make sure to set JP4 to 1-2 to enable the
Power-on password.
2-32
Follow these steps to bypass the
User's Guide
None
.
Advertisement
Table of Contents
