Table of Contents
Advertisement
2.6
Power Management
The Power Management menu allows you to configure the system
power-management feature.
The following screen shows the Power Management parameters and
their default settings:
Power Management Mode................. [Enabled]
IDE Hard Disk Standby Timer......... [Off]
System Sleep Timer.................. [Off]
Sleep Mode........................ [----]
Power Switch < 4 sec. ................ [Suspend]
System Wake-up Event
Modem Ring Indicator................ [Disabled]
2.6.1
Power Management Mode
This parameter allows you to reduce power consumption. When this
parameter is set to
Enabled
system
timers.
Setting
power-management feature and its timers.
IDE Hard Disk Standby Timer
This parameter allows the hard disk to enter standby mode after
inactivity of 1 to 15 minutes, depending on your setting. When you
access the hard disk again, allow 3 to 5 seconds (depending on the
hard disk) for the disk to return to normal speed. Set this parameter to
if your hard disk does not support this function.
OFF
Setup Utility
Power Management
, you can configure the IDE hard disk and
it
to
Disabled
deactivates
the
2-21
Advertisement
Table of Contents
