Checking The Sensors; Checking The Sun Sensor; Checking The Wind Sensor - RADEMACHER ReWiSo 2696 Instruction Manual For The Electrical Connection And For Commissioning

i Commissioning
i

Checking the sensors

In the event of malfunctions of the sensors, error messages are displayed instead
of the values. See also the section "Error messages".

Checking the sun sensor

The brightness can be displayed by briefly pressing the SET button on the operating unit
(see the section "Display of brightness and wind velocity"). The upper value indicates
the brightness in kilolux (kLux).
The sun sensor is located under the opaque glass cover of the weather station.
If the brightness is not sufficient, illuminate the weather station from above using a powerful
torch until a value is displayed.

Checking the wind sensor

The wind velocity can be displayed by briefly pressing the SET button on the operating
unit (see the section "Display of brightness and wind velocity"). The lower value
indicates the velocity in metres per second (m/s). The sensor tube is located on the
front on the underside of the weather station. If you blow into this tube, the displayed
value will change.
Note: The wind velocity is not correctly displayed during the first approx. 90 seconds
after the power is restored to the weather station (e.g. after a power failure or during
commissioning).
36
You are in the basic settings. Continue
as described in section 1 "Radio
connection to the weather station"
for the basic settings.
u Then check the function of the
sensors (see next section).
EN