Installation Of The Weather Station And Connection Of The Drive; Location; Fitting The Bracket - RADEMACHER ReWiSo 2696 Instruction Manual For The Electrical Connection And For Commissioning

i

Installation of the weather station and connection of the drive

Location

Select an installation position on the building where wind, rain and sun can be detected
by the sensors without any impeding structures. No structural parts may be installed
above the weather station from which water could drip onto the precipitation sensor after
it has already stopped raining or snowing. The building or, for example, trees must not
cast shadows onto the weather station. A distance of at least 60 cm must be allowed
under the weather station to permit proper wind measurement and to prevent the
weather station being covered by snow in winter.
The weather station must be installed on a vertical wall (or mast) and aligned
horizontally in the transverse direction.
Wall
or
mast

Fitting the bracket

The weather station includes a combined wall/mast bracket. On delivery, the bracket
is fastened to the rear side of the housing with adhesive tape.
Fasten the bracket perpendicularly to a wall or mast.
Wall installation:
Flat side towards the wall, semi-circular
rib facing upwards.
30
Mast installation:
Curved side towards the mast, rib facing
downwards.
Rib
Horizontal
EN
Rib