Calling Up Service Data; Factory Settings - RADEMACHER ReWiSo 2696 Instruction Manual For The Electrical Connection And For Commissioning

i Service

Calling up service data

The software version of the operating unit and weather station can be shown on the
display. The service area can be called up from the basic settings by holding the
SET button depressed (3 seconds). The software version of the operating unit (
is displayed first; press the SET button briefly to display the software version of the
controller/weather station (
Exit the service data display by pressing the SET button again.
i

Factory settings

The following default settings are stored for automatic mode on delivery of the ReWiSo
controller:
u Sun shading from sun intensity > 40 kLux
u Delay time in the case of sun until the sun shading
- extends: 1 min,
- retracts: 12 min
u Blocking until the indoor temperature > 18°C
u Blocking until the outdoor temperature > 5°C
u Wind alarm from 4 m/s
u Rain alarm activated
). Display 10 means version 1.0, 12 means 1.2, etc.
EN
)
41