Checking The Sensors; Checking The Sun Sensor; Checking The Wind Sensor - RADEMACHER ReWiSo Installation And Operating Instructions Manual

i
Commissioning
i

Checking the Sensors

In the event of malfunctions of the sensors, error messages are displayed instead of
the values. See also section „Error Messages".

Checking the Sun Sensor

The brightness can be displayed by briefly pressing the SET key on the operating unit
(see section „Display of Brightness and Wind Velocity"). The upper value indicates the
brightness in kilolux (kLux).
The sun sensor is located under the opaque glass cover of the weather station. If the
brightness is not sufficient, illuminate the weather station from above using a powerful
torch until a value is displayed.

Checking the Wind Sensor

The wind velocity can be displayed by briefly pressing the SET key on the operating
unit (see section „Display of Brightness and Wind Velocity"). The lower value indicates
the velocity in metres per second (m/s). The sensor tube is located on the front on the
underside of the weather station. If you blow into this tube, the displayed value will
change.
Note: The wind velocity is not correctly displayed during the first approx. 90 seconds
after the power is restored to the weather station (e.g. after a power failure or during
commissioning).
174
You are in the basic settings.
Process as described in section
„1. Radio Link to the Weather Sta-
tion" for the basic settings.
Then check the function of
the sensors (see next sec-
tion).
GB