Installation Of The Weather Station And Connection Of The Drive; Location; Installation Of The Bracket - RADEMACHER ReWiSo Installation And Operating Instructions Manual

i

Installation of the Weather Station and Connection of the Drive

Location

Select an installation position on the building where wind, rain and sun can be detected
unhindered by the sensors. No structural parts may be installed above the weather
station from which water could drip onto the precipitation sensor after it has already
stopped raining or snowing. The building or, for example, trees must not cast shadows
onto the weather station. A distance of at least 60 cm must be allowed under the
weather station to permit proper wind measurement and to prevent the weather station
being covered by snow in winter.
The weather station must be installed on a vertical wall (or mast) and aligned
horizontally in transverse direction.
Wall
or
mast

Installation of the Bracket

The weather station includes a combined wall/mast bracket. On delivery, the bracket is
fastened to the rear of the housing with adhesive tape.
Fasten the bracket perpendicularly to a wall or mast.
Wall installation:
Flat side towards the wall, semi-
circular rib facing upwards.
168
Mast installation:
Curved side towards the mast, rib
facing downwards.
Rib
Horizontal
GB
Rib