Bearing Outer Race - Acura NSX 1991 Manual

Main Menu
Illustrated Index
Clean all parts thoroughly in solvent and dry with compressed air.
Lubricate all parts with oil before reassembly.
NOTE:
This transmission uses no gaskets between the major housings; use P/N 08718 — 0001 sealant.
Assemble the housings within 20 minutes after applying the sealant and allow it to cure at least 30 minutes after
assembly before filling the transmission with oil.
Always clean the magnet
CLUTCH RELEASE HANGER
RELEASE HANGER SPRING
RELEASE BEARING GUIDE
40 x 68 x 12.5 mm OIL SEAL
Replace.
10 x 20 mm DOWL PIN
CLUTCH HOUSING
SPEED SENSOR
SENSOR DUMMY COVER
O-RING
Replace.
HOLDER PLATE
REVERSE SHIFT FORK ASSEMBLY
Disassembly/Reassembly, page
13-16
REVERSE IDLE GEAR SHAFT
ASSEMBLY
Disassembly/Reassembly, page
13-15
Table of Contents
whenever the transmission housing is disassembled.
OIL GUIDE RING
90 mm WASHER

BEARING OUTER RACE

DIFFERENTIAL ASSEMBLY
See section 15
OIL GUIDE PLATE
44 x 72 x 23 mm NEEDLE BEARING
BEARING RETAINING PLATE
COUNTERSHAFT ASSEMBLY
Index, page
MAINSHAFT ASSEMBLY
Index, page
75 mm SPRING WASHER
32 x 46 x 7 mm OIL SEAL
Replace.
13-29
13-23
TRANSMISSION MAGNET
SHIFT FORK ASSEMBLY
Disassembly/Reassembly, page
13-22
OIL PUMP ASSEMBLY
Disassembly/Reassembly, page
13-37
CHANGE HOLDER ASSEMBLY
Disassembly/Reassembly, page
13-19
UPPER COVER
SELECT LEVER ASSEMBLY
Removel, page 13-17
Installation, page 13-43
REVERSE SHIFT ARM
14x20 mm DOWEL PHIS
14 x 20 mm DOWEL PIN