Table of Contents
Advertisement
2) General Descriptions/ Specifications/ Features
General Description
The Corbin Russwin Access 800 WI1 WiFi lock uses IEEE 802.11 b/g WiFi infrastructure to
connect to the access control system, making it ideal for adding access control to areas of a
building that would be too difficult or costly to wire. With no wires to run, it significantly
reduces hardware and labor costs.
The Access 800 IP1 PoE lock uses a single Ethernet cable for both power and data, eliminating
the need for any additional power supply or electrical wiring. It uses existing IEEE 802.3af PoE
infrastructure to streamline the installation process, reduce costs, enable real-time
communication, and minimize power consumption.
Specifications
• Latch
•
•
•
Features
• Intelligent, integrated ANSI/BHMA Grade 1 lockset, available in cylindrical lock,
mortise lock, and exit device configurations, offers the highest degree of physical
security available in access control locks
• Local decision making ensures operation regardless of network status
• Built-in door status monitoring and real-time, configurable alarm notifications
• Supports 2,400 users and 10,000 event audit trail
®
• Supports HID 125 kHz prox or 13.56 MHz iCLASS credentials (26 - 39 bit);
supports CSN reads for other common 13.56 MHz cards, including MiFare,
DesFire, and Felica
• Available with a keypad option for two-factor authentication
• Weatherseal gaskets and conduit included for use on exterior doors
• WiFi version (TCWI1) uses 6 AA alkaline batteries or remote electrical power
• PoE version (TCIP1) is a Class 2 device, as defined by IEEE 802.3af, requiring a
maximum of 7 watts
•
•
®
4
ASSA ABLOY
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®
Advertisement
Table of Contents
